Easily program your electronic bottle fillers after installation or maintenance!
Welcome to the OASIS bottle filler programming guide. To begin open your box and confirm that there is a programmer along with a battery pack. Click the top button and see how much charge it has. It recharges to include a micro USB cable.
To begin with, plug in the programer to the battery pack in the back. You should see all the lights light up and then switch to a blue blinking light on the status.
Open up your OASIS bottle filler and locate the PCB on the back of the unit. You will have to line up three locating pins next to the large black chip, with the three locating pins on the programmer. After you have it all connected hit the button on the front of the programmer and watch as the lights will flash. Wait until the status light turns green and the active light resumes flashing blue.
After that, remove the programmer and using the button attached to the PCB – click once. You should then see on the front it say FW REV 16.24 (Firmware Revision).
Questions or issues? Contact us; our tech services specialists can assist with installation walk-throughs, troubleshooting, and product and technical questions.
OASIS Technical Support
Phone: 800.646.2747
Email: tech@oasiscoolers.com